Cleaning the Burner Assembly
Follow these instructions to clean and/or replace parts of burner assembly or if you have trouble igniting grill.
1.Turn gas off at control knobs and gas source.
2.Remove cooking grates, burner tents and tent frames.
3.Under grill remove soup can from grease clip.
4.Beneath grill bottom remove ignitor wires by pulling down on ceramic insulator (A).
5.Under console disengage (A) clips by lightly pushing clip on burner tube away from you and pull down. Remove burners and shield from grill bottom.
6.Wipe ceramic electrodes (A) with rubbing alcohol and cloth.
7.Clean burners exterior with soap and water. Lay burners on flat surface, insert garden hose (preferably with nozzle), into burner tubes forcing water through tubes. Make sure water comes out of every porthole. Open clogged portholes with a thin wire. Shake out excess water and examine portholes. Due to normal wear and corrosion some portholes may become enlarged, if so replace burner. If any horizontal cracks appear from porthole to porthole or large holes (other than portholes) are found replace burner. Use a wire brush to clean
8.If grill is to be stored, coat burners lightly with cooking oil. Wrap in protective cover to keep insects out. If not storing use following steps.
9.Place shield into bottom of grill then burners. Attach burners into valves, under grill bottom reattach clips.
VERY IMPORTANT: Burner tubes must engage valve openings as shown.
10.Attach ceramic insulators with ignitor wire to burners.
11.Reposition cooking grates, tent frames and burner tents. Reattach soup can to grease clip under grill bottom.
12.Before cooking again on grill, follow “Burner Flame Check”.
Burner
Tube
Valve
Ceramic Insulator
A
Clip
14 • 4638234
