WARNING |
•Do not use grill until
•If a leak is detected at any time, STOP!
•If you cannot stop a gas leak by closing the LP cylinder valve leave area and call your fire department!
Leak Testing Valves, Hose and Regulator
1.Turn all grill control knobs to OFF.
2.Be sure regulator is tightly connected to LP cylinder.
3.Completely open LP cylinder valve by turning hand wheel counterclockwise. If you hear a rushing sound, turn gas off immediately. There is a major leak at the connection. Correct before proceeding.
4.Brush soapy solution onto areas circled below, or other similar fittings on your grill.
•If you notice grease or other hot material dripping from grill onto valve, hose or regulator, turn off gas supply at once. Determine the cause, correct it, then clean and inspect valve, hose and regulator before continuing. Perform a leak test.
•Keep ventilation openings in cylinder enclosure (grill cart) free and clear of debris.
•Do not store objects or materials inside the grill cart enclosure that would block the flow of combustion air to the underside of either the control panel or the firebox bowl.
•The regulator may make a humming or whistling noise during operation. This will not affect safety or use of grill.
•If you have a grill problem see the "Troubleshooting” Section.
•If the regulator frosts, turn off grill and LP cylinder valve immediately. This indicates a problem with the cylinder and it should not be used on any product. Return to supplier!
Ignitor Lighting
•Do not lean over grill while lighting.
1.Turn 
OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.To ignite, push and turn IGNITION BURNER knob to 
HIGH.
5.Immediately, push and hold ELECTRONIC IGNITION button until the burner lights.
6.If ignition does NOT occur in 5 seconds, turn the burner controls 
OFF, wait 5 minutes and repeat the lighting procedure. If ignitor does not work, follow match lighting instructions.
7.To ignite remaining burners, turn knob to the 
HIGH position starting with the burners closest to IGNITION BURNER first.
8.For grills equipped with ELECTRONIC IGNITION at each burner:
Repeat steps 4 through 6 to light each burner.
NOTE: Sideburner | NOTE: Your grill |
shelf fascia and other | may NOT be |
parts not shown for | equipped with a |
clarity. | sideburner. |
5.If “growing” bubbles appear, there is a leak. Close LP cylinder valve immediately and retighten connections. If leaks cannot be stopped do not try to repair. Call for replacement parts.
6.Always close LP cylinder valve after performing leak test by turning hand wheel clockwise.
WARNING |
•Outdoor gas appliance is not intended to be installed in or on a boat.
•Outdoor gas appliance is not intended to be installed in or on an RV.
•Never attempt to attach this grill to the
Safety Tips
•Before opening LP cylinder valve, check the coupling nut for tightness.
•When grill is not in use, turn off all control knobs and LP cylinder valve.
•Never move grill while in operation or still hot.
•Some surfaces will be hot during use. Use long- handled barbecue utensils and oven mitts to avoid burns and splatters.
•Maximum load for sideburner and side shelf is 10 lbs.
•The grease tray or cup must be installed during use and emptied after each use. Do not remove grease tray or cup until grill has completely cooled.
•Clean grill often, preferably after each cookout. If a bristle brush is used to clean any of the grill cooking surfaces, ensure no loose bristles remain on cooking surfaces prior to grilling. It is not recommended to clean cooking surfaces while grill is hot.
WARNING
For Safe Use of Your Grill and to Avoid Serious Injury:
•Do not let children operate or play near grill.
•Keep grill area clear and free from materials that burn.
•Do not block holes in sides or back of grill.
•Check burner flames regularly.
•Use grill only in
•Do not use charcoal or ceramic briquets in a gas grill.
•Do not cover grates with aluminum foil or any other material. This will block burner ventilation and create a potentially dangerous condition resulting in property damage and/or personal injury.
•Use grill at least 3 ft. from any wall or surface. Maintain 10 ft. clearance to objects that can catch fire or sources of ignition such as pilot lights on water heaters, live electrical appliances, etc.
. | 3 |
|
ft | ft. | |
3 |
| |
|
|
•NEVER attempt to light burner with lid closed. A buildup of
•Never operate grill with LP cylinder out of correct position specified in assembly instructions.
•Always close LP cylinder valve and remove coupling nut before moving LP cylinder from specified operation position.
•Apartment Dwellers:
Check with management to learn the requirements and fire codes for using an LP gas grill in your apartment complex. If allowed, use outside on the ground floor with a three (3) foot clearance from
walls or rails. Do not use on or under balconies.
9.Once each burner has ignited, turn knobs to desired setting.
WARNING
Turn controls and gas source or tank OFF when not in use.
CAUTION
If ignition does NOT occur in 5 seconds, turn the burner controls 
OFF, wait 5 minutes and repeat the lighting procedure. If the burner does not ignite with the valve open, gas will continue to flow out of the burner and could accidently ignite with risk of injury.
Match-Lighting
•Do not lean over grill while lighting.
1.Turn 
OFF gas burner control valves.
2.Turn ON gas at LP cylinder.
3.Open lid during lighting.
4.Place match into match holder (hanging from side panel of grill). Light match; then light burner by placing match through the match light hole on side of grill.
5.Push in and turn burner knob to the 
HIGH position. Be sure burner lights and stays lit.
6.Light adjacent burners in sequence by pushing knobs in and turning to the 
HIGH position.
6
