Char-Broil 5101194 Use appliance at least 3 ft, Apartment Dwellers, Burner Check, Ignitor Check

WARNING

For Safe Use of Your Outdoor Stove Top and to Avoid Serious Injury:

•Do not let children operate or play near appliance.

•Keep appliance area clear and free from materials that burn.

•Do not block holes in sides or back of appliance.

•Check burner flames regularly.

•Use appliance only in a well-ventilated space. NEVER use in enclosed space such as carport, garage, porch, covered patio, or under an overhead structure of any kind.

•Do not use charcoal or ceramic briquets in a gas appliance. (Unless briquets are supplied with your appliance.)

•Use appliance at least 3 ft.

from any wall or surface. Maintain 10 ft. clearance to objects that can catch fire or sources of ignition such as pilot lights on water heaters, live electrical appliances, etc..

•Apartment Dwellers:

Check with management to learn the requirements and fire codes for using an LP gas appliance in your apartment complex. If allowed, use outside on the ground floor with a three (3) foot clearance from walls or rails. Do not use on or under balconies.

•NEVER attempt to light burner with lid closed. A buildup of non-ignited gas inside a closed appliance is hazardous.

•Never operate appliance with LP cylinder out of correct position specified in assembly instructions.

•Always close LP cylinder valve and remove coupling nut before moving LP cylinder from specified operation position.

Ignitor Lighting

1.Open lid during lighting.

2.Press and turn the control knob to the HI position.

3.Turn ROTARY IGNITOR knob rapidly.

4.If ignition does not occur in 5 seconds, turn the burner control knob OFF, wait 5 minutes, and repeat lighting procedure. If ignition still does not occur, follow “Match Lighting” instructions.

CAUTION

If burner does not light turn knob to OFF, wait 5 minutes, try again. If the burner does not ignite with valve open, gas will continue to flow out of the burner and could accidentally ignite with risk of injury.

Match Lighting

Do not lean over appliance while lighting. Use a large kitchen match or fireplace match to light the appliance.

1. Place a lit match to burner.

2.Press and turn control knob To HI.

Burner Flame Check
• Light burner, rotate knob	HI

from HI to LOW. You

LOW

should see a smaller flame in LOW position

than seen on HI. Always check flame prior to each use.

Burner Check

•Inspect burner prior to each use. If burner is damaged do not use. Call manufacturer at 1-800-232-3398 to obtain a replacement.

Turning Appliance Off

•Turn knob to OFF position. Turn LP cylinder OFF by turning handwheel clockwise to a full stop.

Ignitor Check

•Turn gas OFF at LP cylinder. Turn ignitor knob rapidly. “Click” should be heard and spark seen each time between burner and electrode. See “Troubleshooting” if no click or spark.

Valve Check

•Important: Make sure gas is OFF at LP cylinder before checking valves. Knob locks in OFF position. To check valve, first push in knob and release, knob should spring back. If knob does not spring back, replace valve assembly before using appliance. Turn knob to MED position then turn back to OFF position. Valve should turn smoothly.

Hose Check

•Before each use, check to see if hose is cut or worn. Replace damaged hose before using appliance. Use only hose/valve/regulator specified by manufacturer.

7