Setup
•All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0% to 100% switch.
•Before applying power to a fixture, check that the source voltage matches the fixture’s requirement.
•All fixtures must be connected to circuits with a suitable Earth Ground.
Mounting
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs.
•When selecting installation location, take into consideration lamp replacement access and routine maintenance.
Hanging Clamp
Clamp sold separately!
•Safety cables should always be used.
•Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
These holes can be used to mount hanging clamps for downlighting positions off a truss
Top View
Front View
The
Side View
6 |
