Chauvet DERBY X user service Off, Setting the Starting Address

SETTING THE STARTING ADDRESS

This DMX mode enables the use of a universal DMX controller device. Each fixture requires a "start address" from 1 to 512. A fixture requiring one or more channels for control begins to read the data on the channel indicated by the start address. For example, a fixture that uses 6 DMX channels and was addressed to start on DMX channel 100, would read data from channels: 100, 101, 102, 103, 104, and 105. Choose start addresses so that the channels used do not overlap, and note the start address selected for future reference.

If this is your first time addressing a fixture using the DMX-512 control protocol, we suggest jumping to the Appendix Section and reading the heading “DMX Primer”. It contains very useful information that will help you understand its use.

Set the start address using the group of DIP switches located usually on bottom of the fixture. Each dip switch has an associated value. Adding the value of each switch in the ON position will provide the start address. Figuring out which switches to toggle ON given a specific start address can be accomplished by determining which switch values will add up to the address value and turning these switches on. Do so by doing the following:

1)Determine the largest value switch that is less than the start address. Turn this switch on.

2)Subtract the value of the switch you just turned on from the starting address number.

3)Determine the largest value switch that is less than the remainder from the previous subtraction. Turn this switch on.

4)Subtract the value of the switch you just turned on from the remainder of the previous subtraction.

5)Repeat steps three and four until you have a remainder of zero.

Example Starting Address

Address 10

Switch # 4	= 8
Switch # 2	= 2
Total	= 10

Address 24

Switch # 5 = 16 Switch # 4 = 8

Total = 24

Resolving address using simple math.

Address 233

256	128	64	32	16	8	4	2	1
9	8	7	6	5	4	3	2	1

ON OFF

256	128	64	32	16	8	4	2	1
9	8	7	6	5	4	3	2	1	ON
									OFF
233 – (128) = 105, Turn ON Dip # 8							DIPSWITCH		(DMX VALUE)
105 – (64) = 41, Turn ON Dip # 7
41 – (32) = 9, Turn ON Dip # 6								1	1
9 – (8) = 1, Turn ON Dip # 4								2	2
1 – (1) = 0, Turn ON Dip # 1								3	4
								4	8
								5	16
								6	32
								7	64
								8	128
								9	256

Derby X™ User Manual 12 7/14/2008 1:27 PM