Setup
Mounting
ORIENTATION
This fixture may be mounted in any position provided there is adequate room for ventilation.
RIGGING
It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs.
•When selecting installation location, take into consideration lamp replacement access and routine maintenance.
•Safety cables should always be used.
•Never mount in places where the fixture will be exposed to rain, high humidity, extreme temperature changes or restricted ventilation.
Hanging Clamp
Note!
Clamp is sold separately.
Manual Focusing
To adjust the focus, please follow the instructions below.
1)If operating in stand alone mode, turn the music down so that the unit temporarily stops any activity, other wise turn the lamp on using Channel 4.
2)Rotate the lens gun either clockwise or counter- clockwise until the spot is defined by a hard edge.
Rotate lens gun clockwise and counter- clockwise to achieve desired
IN
Fuse Replacement
Disconnect the power cord before replacing a fuse and always replace with the same type fuse.
With a flat head screwdriver wedge the fuse holder out of its housing. Remove the damaged fuse from its holder and replace with exact same type fuse. Insert the fuse holder back in its place and reconnect power.
The fuse is located inside this compartment. Remove using a flat head screwdriver.
7 | Revision: 10/11/2006 1:11 PM |
