Chauvet DMX-800 Menu Functions , Operation Stand-Alone Mode (Sound-Active, Auto Mode): , Master/Slave Mode (Master Sound, Master Auto):

Menu Functions

DMX: The fixture will be controlled by a DMX signal coming from a DMX controller.

The starting address must be selected, and can be set using the up and down

buttons.

Slave Unit: Sets the fixture to run in sync with the Master. You must set the first

fixture in the data link to “Master” otherwise nothing will happen.

Sound Active – Master Unit: Sets the fixture to Master status for Master-Slave

operation and the built in programs will be triggered by the sound. No data link is

required; all fixtures can be set to this mode for Stand-alone operation.

Automatic – Master Unit: Sets the fixture to Master status for Master-Slave

operation and the built in programs will be triggered automatically to a pre-

programmed time interval. No data link is required; all fixtures can be set to this mode

for Stand-alone operation.

Blackout – Master Unit: Sets the fixture to Master status for Master-Slave operation

and closes the shutter. No data link is required; all fixtures can be set to this mode for

blackout operation.

13 Channel Mode: Sets the fixture to operate in 13 channel mode.

19 Channel Mode: Sets the fixture to operate in 19 channel mode.

Operation Stand-Alone Mode (Sound-Active, Auto Mode):

This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto

Mode.

1) Press <MODE/ESC> until , , or is displayed.

2) Use the <UP> and <DOWN> buttons to scroll through until the desired mode is displayed.

is auto mode; is sound-active.

3) The unit will react to the low frequencies of music via the internal microphone in Sound-Active

mode, or the unit will auto change in Auto Mode.

Master/Slave Mode (Master Sound, Master Auto):

This mode will allow you to link up to 32 units together without a controller.

1) Use standard DMX cables to daisy chain your units together via the DMX connector on the rear

of the units. For longer cable runs we suggest a terminator at the last fixture. For more

information about terminators, see page 9.

2) Choose a unit to function as the master. Press <MODE> until , , or

is displayed on the master unit.

3) Use the <UP> and <DOWN> buttons to scroll through until the desired mode is displayed.

is auto mode; is sound-active.

4) Press <MODE> until, is displayed on the slave units.

Constellation User Manual 12 2007-01-09/10:53