Chauvet DMX512 user manual Before You Begin, What is Included, Unpacking Instructions, AC Power

1.BEFORE YOU BEGIN

What is Included

Ø	1 x LED Mushroom	Ø	Warranty Card
Ø	Power Cord	Ø	User Manual

Unpacking Instructions

Immediately upon receiving a fixture, carefully unpack the carton, check the contents to ensure that all parts are present, and have been received in good condition. Notify the shipper immediately and retain packing material for inspection if any parts appear damaged from shipping or the carton itself shows signs of mishandling. Save the carton and all packing materials. In the event that a fixture must be returned to the factory, it is important that the fixture be returned in the original factory box and packing.

AC Power

This fixture has an auto-switching power supply that can accommodate a wide range of input voltages. The only thing necessary to do before powering on the unit is to make sure the line voltage you are applying is within the range of accepted voltages. This fixture will accommodate between 100V and 240V AC 50-60 Hz. All fixtures must be powered directly off a switched circuit and cannot be run off a rheostat (variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used solely for a 0–100% switch.

Safety Instructions

Please read these instructions carefully, which includes important information about the installation, usage and maintenance of this product.

·Please keep this User Manual for future consultation. If you sell the unit to another user, be sure that they also receive this instruction booklet.

·Always make sure that you are connecting to the proper voltage, and that the line voltage you are connecting to is not higher than that stated on the decal or rear panel of the fixture.

·This product is intended for indoor use only! (If applicable)

·To prevent risk of fire or shock, do not expose fixture to rain or moisture. Make sure there are no flammable materials close to the unit while operating.

·The unit must be installed in a location with adequate ventilation, at least 20in (50cm) from adjacent surfaces. Be sure that no ventilation slots are blocked.

·Always disconnect from power source before servicing or replacing lamp or fuse and be sure to replace with same lamp source.

·Secure fixture to fastening device using a safety chain. Never carry the fixture solely by its head. Use its carrying handles.

·Maximum ambient temperature (Ta) is 104°F (40°C). Do not operate fixture at temperatures higher than this.

·In the event of a serious operating problem, stop using the unit immediately. Never try to repair the unit by yourself. Repairs carried out by unskilled people can lead to damage or malfunction. Please contact the nearest authorized technical assistance center. Always use the same type spare parts.

·Never connect the device to a dimmer pack.

·Make sure the power cord is never crimped or damaged.

·Never disconnect the power cord by pulling or tugging on the cord.

·Avoid direct eye exposure to the light source while it is on.

·Do not daisy chain power to more than 37 units @ 120V and 70 @ 230V.

Caution!	There are no user-serviceable parts. Do not open the housing or attempt any
	repairs yourself. In the unlikely event your unit may require service, please contact
	CHAUVET® at: 954-577-4455.

LED Mushroom User Manual 3 Rev. 4