DMX Operation
This is the operating mode, which will allow for control using an external DMX controller. You must set the starting address for this mode.
If this is your first time using DMX, refer to the “DMX Primer” section in the Appendix of this manual.
1. Press <MENU> until | ~ | appears on the LED screen. |
2.Press <ENTER>.
3.Using <UP> and <DOWN>, select the starting address.
4.Press <ENTER>.
All fixtures must be individually set to DMX using the instructions above.
Master/Slave Mode (Sound-Active, Auto Mode)
This mode allows a single unit to run to the beat of the music, or the unit will change automatically. DMX cables must be used to daisy chain between the fixtures from the output of the master unit.
Master:
1.Set the master unit to run in either Automatic mode or
Slave: |
|
|
1. Press <MENU> until | ~ | appears on the LED screen. |
2.Press <ENTER>.
3. | Using <UP> and <DOWN>, select the starting address of | . |
4. | Press <ENTER>. |
|
All fixtures must be individually set to either master or slave mode using the instructions above.
Only set one fixture to master. Having two or more master fixtures in the same daisy chain will prevent the fixtures from working properly.
Do not connect a DMX controller in this setup.
4. Operating Instructions | 10 | 8/31/2010 4:41 PM |
