Chauvet FX 2.0, RGX 2.0 user manual Appendix, General Troubleshooting

5. APPENDIX

General Troubleshooting

SYMPTOM	POSSIBLE CAUSE(S)	POSSIBLE ACTION(S)
	 Excessive circuit load	 Check total load placed on the
Breaker/Fuse		electrical circuit.
keeps blowing	 Short circuit along the power	 Check for a short in the electrical
	wires	wiring (internal and/or external).
Device does not	 No power	 Check for power on Mains.
power up	 Loose power cord	 Check power cord
	 Wrong DMX addressing	 Check Control Panel and unit
		addressing
Product is not	 Damaged DMX cables	 Check DMX cables
	 Wrong polarity settings on the	 Check polarity switch settings on
responding to
	controller	the controller
DMX
	 Loose DMX cables	 Check cable connections
	 Faulty DMX interface	 Replace DMX input
	 Faulty Main PCB	 Replace Main PCB
	 Non DMX cables	 Use only DMX compatible cables
	 Bouncing signals	 Install terminator as suggested.
	 Long cable / Low level signal	 Install amplifier right after product
Loss of signal		with strong signal.
	 Too many products	 Install an optically coupled DMX
		splitter after unit #32.
	 Interference from AC wires	 Keep DMX cables separated from
		power cables or black lights.

If you still have a problem after trying the above solutions, please contact CHAUVET®

Technical Support.

MinLasers 2.0 User Manual 13 August 2011