Chauvet Satellite TV System Operating Instructions, Using the control panel, Mode Selection

4.OPERATING INSTRUCTIONS

Using the control panel

Press <MODE> to switch between transmit and receive mode; this will also enable the frequency assignment.

Press <DOWN/UP> to scroll through the operating frequencies.

Press <ENTER> to save the settings.

Menu Option

Description

Receive mode: Sets the Satellite™ D-Fi/D-Fi™ PLUS to receive from a transmitting D-Fi™ PLUS operating on the same frequency

Transmit mode: Sets the Satellite™ D-Fi/D-Fi™ PLUS to transmit to a receiving Satellite™ D-Fi/D-Fi™ PLUS operating on the same frequency

Operating frequency: from to

A system is one Satellite™ D-Fi/D-Fi™ PLUS transmitting and one or more Satellite™ D-Fi/D-Fi™ PLUS units receiving on the same frequency.

A minimum of 2 Satellite™ D-Fi/D-Fi™ PLUS units are required for operation.

Mode Selection

Each Satellite™ D-Fi may be used as a transmitter or a receiver, and is thereby referred to as a transceiver. In order to the appropriate mode, please see the following steps.

1.Press <MODE>. The first group of segments on the LED display will begin blinking rapidly.

2. Press <MODE> again to change between (receive) and (transmit).

3.Press <ENTER>.

Frequency Selection

An operable system requires one transmitter and at least one receiver to be used on the same frequency. Please see the steps below for instructions on how to set the frequency.

1.Press <MODE>. The first group of segments on the LED display will begin blinking rapidly.

2.Use <UP> and <DOWN> to select the frequency

3.Press <ENTER>.

4. Operating Instructions 11 12/28/2009 12:38 PM