Operation
DMX Operation
This is the operating mode which will allow for control with an external DMX controller. You must set the starting address for this mode. If this is your first time using DMX, then it is recommended that you refer to the “DMX Primer” section in the “Appendix” of this manual.
1.Press <MODE/ESC> until d*** appears on the LED screen.
2.Using <UP> and <DOWN>, select the starting address (001~512).
3.Press < ENTER > until one of the DMX personalities appears on the LED screen (8-
CH, 11-CH).
4.Using <UP> and <DOWN>, select the desired DMX personality.
5.Press <ENTER>.
Only connect 32 fixtures to a single DMX daisy chain!
Master/Slave Mode (Sound-Active, Auto Mode)
This mode allows a single unit, the master, to operate in one of the standalone modes, while one or more fixtures, slaves, synchronize their responses to the master.
Master:
The master fixture may be set in any of the STANDALONE modes:
slow.
Slave:
1.Press <MENU> until SLAu appears on the LED screen.
2.Press < ENTER >.
Only connect 31 slave fixtures when operating in this mode!
Automatic-Slow
This fixture has a preprogrammed chase that will operate in a preprogrammed, slow playback speed.
Access this mode via the control panel on the front of the fixture. Please see the instructions below for further explanation.
1.Press <MODE/ESC> until one of the standalone modes appears on the LED screen
(SLAv, NStS, NAFA, NASL).
2.Using <UP> and <DOWN>, select NASL.
3.Press <ENTER>.
Automatic-Fast
This fixture has a preprogrammed chase that will operate in a preprogrammed, fast playback speed.
Access this mode via the control panel on the front of the fixture. Please see the instructions below for further explanation.
1.Press <MODE/ESC> until one of the standalone modes appears on the LED screen
(SLAv, NStS, NAFA, NASL).
2.Using <UP> and <DOWN>, select NAFA.
3.Press <ENTER>.
4. Operating Instructions | 10 | 10/25/2010 10:23 AM |