Chauvet Vue II Stand-Alone/Master/Slave Fixture Linking, Mounting, Orientation, Rigging

Stand-Alone/Master/Slave Fixture Linking

1.Connect the (male) 3 pin connector side of the DMX cable to the output (female) 3 pin connector of the first fixture.

2.Connect the end of the cable coming from the first fixture which will have a (female) 3 pin connector to the input connector of the next fixture consisting of a (male) 3 pin connector. Then, proceed to connect from the output as stated above to the input of the following fixture and so on.

Often, the setup for Master-Slave and Standalone operation requires that the first fixture in the chain be initialized for this purpose via either settings in the control panel or DIP- switches. Secondarily, the fixtures that follow may also require a slave setting. Please consult the “Operating Instructions” section in this manual for complete instructions for this type of setup and configuration.

Mounting

ORIENTATION

This fixture may be mounted in any position provided there is adequate room for ventilation.

RIGGING

Hanging Clamp

It is important never to obstruct the fan or vents pathway. Mount the fixture using, a suitable “C” or “O” type clamp. Adjust the angle of the fixture by loosening both knobs and tilting the fixture. After finding the desired position, retighten both knobs.

•When selecting installation location, take into consideration lamp replacement access and routine maintenance.

•	Safety cables should always be used.	Note!
•	Never mount in places where the fixture will be exposed to rain, high	Clamp is sold separately.
	humidity, extreme temperature changes or restricted ventilation.

Vue™ II User Manual 9 2007-05-10/13:15