4.OPERATING INSTRUCTIONS
Operation
This mode allows a single unit to run to the beat of the music, or the unit will auto change in Auto Mode.
1)Set dipswitches position to
Mode | Dipswitches |
Auto Mode | |
Strobe Mode | |
All On |
*Effect speed | **Strobe speed |
1 on = slow | |
5 on = slow strobing | |
2)The unit will react to the low frequencies of music via the internal microphone in
3)Use the audio sensitivity knob on the back of the unit to make the unit more or less sensitive in
Master/Slave Mode (Master Sound, Master Auto):
This mode will allow you to link up to 32 units together without a controller.
1)Use standard DMX cables to daisy chain your units together via the DMX connector on the rear of the units. For longer cable runs we suggest a terminator at the last fixture. For more information about terminators, see page 8.
2)Determine which fixture will be the master. Connect a DMX cable from the DMX output connector of the master to the DMX input connector of another Vue I™ or Vue II™.
3)Continue connecting the slaves together with DMX cables
4)Set the dipswitches on the master according to the desired mode of operation.
Mode | Dipswitches |
Master Sound | 9 = On, 10 = Off |
Master Auto | 9 = Off, 10 = On |
5)For auto mode, set dipswitches to the desired mode.
Mode | Dipswitches |
Auto Mode | |
Strobe Mode | |
All On |
*Effect speed | **Strobe speed |
1 on = slow | |
5 on = slow strobing | |
Vue™ II User Manual | 10 |