Page 12SKU 40315 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Blade Diameter
(Blade Not Included,
Sold Separately)
7"
(67393 7” Continuous
Rim Diamond Blade
Recommended)
Arbor Diameter 1"
Maximum Cutting
Capacity 1” Thick, 12” Wide
Electrical Requirements 120 V~ / 60 Hz / 5 A
Single Phase
Tilting Head 45° for Bevels
Blade Rated Speed 3565 RPM
Table Size 15-3/4” x 16-1/2”
Accessories 1 Spanner Wrench
1 Nut Driver
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
INSTRUCTIONS FOR PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.

Assembly

To Permanently Mount Tile Saw On A
Workbench:
1. WARNING! Make sure the Power
Switch (21) of the Tile Saw is in
its “OFF” position and its Power
Cord/Plug (34) is unplugged from
the electrical outlet prior to per-
forming any assembly.
2. The Tile Saw may be temporarily
placed upon a workbench for use.
Also, the Tile Saw may be perma-
nently mounted on a workbench.
3. CAUTION! Make sure the work-
bench on which the Tile Saw will be
temporarily or permanently used is
at, level, sturdy enough to support
the weight of the Tile Saw, any work-
pieces, and any additional tools, and
is not affected by spilled water.
4. To permanently mount the Tile Saw
on a workbench, place the Tile Saw
in the desired work location on the
workbench. Use the four 7/16” wide
x 3-1/2” long mounting slots at the
base of the Inner Cover (16) as a
template to mark the areas where
four 7/16” diameter mounting holes
should be drilled through the work-
bench. WARNING! Before drilling,
verify there are no hidden utility wires
below work surface.
5. Temporarily remove the Tile Saw, and
drill the four 7/16” diameter mounting
holes through the workbench, mak-