Page 16SKU 40315 For technical questions, please call 1-800-444-3353.
MAINTENANCE AND SERVICING
Procedures not specically
explained in this manual
must be performed only by a
qualied technician.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
TO PREVENT SERIOUS
INJURY FROM TOOL
FAILURE:
Do not use damaged
equipment. If abnormal noise
or vibration occurs, have the
problem corrected before
further use.

Cleaning, Maintenance, and

Lubrication

1. BEFORE EACH USE, inspect the
general condition of the tool. Check
for loose screws, misalignment or
binding of moving parts, cracked or
broken parts, damaged electrical
wiring, loose or worn out blade, and
any other condition that may affect its
safe operation.
2. AFTER USE, clean external surfaces
of the tool with clean cloth. Drain wa-
ter from the water tray and wash out
any residue.
3. Tool service must be performed
only by qualied repair personnel.
Service or maintenance performed by
unqualied personnel could result in
a risk of injury.
4. When servicing a tool, use only
identical replacement parts. Fol-
low instructions in the “Inspec-
tion, Maintenance, And Cleaning”
section of this manual. Use of
unauthorized parts or failure to follow
maintenance instructions may create
a risk of electric shock or injury.
5. WARNING! If the supply cord of
this power tool is damaged, it must
be replaced only by a qualied
service technician.
6. WARNING! Always turn the
Tool Saw’s Power Switch (21) to
its “OFF” position and unplug
the tool from its electrical outlet
before performing any inspection,
maintenance, or cleaning.
7. To install a Cutting Wheel Blade:
A. Make certain power is
disconnected and the power
switch is in the “OFF” position.
B. Empty the Tray (17). Turn it 90°
(sideways) and remove it.
C. Remove the Screws (2) and
Washers (3). Remove the Front
Cover (1), and Rear Blade
Cover (58).
D. Use the prongs on the Spanner
Wrench (59) to hold the Outside
Flange (7) while you use the
Nut Driver (60) to remove the
Nut (4). Remove the old Cutting
Wheel Blade.
E. Install a new 67393 7”
Continuous Rim Diamond Blade
REV 10e