Using the Workpiece Extension Supports
1.The Table Extensions are inserted into each side of the Base, and locked in place using the Wing Screws.
2.When properly installed, the upper face of the Table Extensions are level with the Table, and provide a wider support surface for the workpiece.
3.Support the workpiece to be level with the Table, and so that after the cut is made the cut off pieces will not fall. Use sawhorses or other supports (not included) to support longer workpieces.
4.If the workpiece is not level, an unintentional bevel cut will be made in the material. If the workpiece is not supported, it will bind the blade and may cause the material to kick back, potentially causing injury.
Safety
Adjusting the Miter Angle
A miter cut is one that is at an angle across the horizontal surface of the material. 45º miter cuts to join two pieces in a right angle corner are common. A 30º cut is often used for a scarf joint or to make a chamfered end.
1.Loosen the Miter Knob by turning it approximately 2 turns counterclockwise.
2.Press down the Miter Lock to unlock the Table. While holding the Miter Lock down,
move the Table to the desired angle.
3.The Miter Angle Indicator will indicate the selected angle. While the Miter Lock is released, the table will lock into place at often used miter angles, including 22.5º, 30º, 45º, and 90º on both left and right sides.
4.Tighten the Miter Knob after adjusting the miter angle.
5.With the Table adjusted to the desired angle, place the workpiece flush against the Fence, secure it with the Clamp and make the cut.
Setup
Adjusting the Bevel Angle
A bevel cut is one that is at an angle vertically. Bevel cuts can be used to cut a miter in relatively wide and thin material. Bevel cuts can be used in combination with a miter cut to form a compound angle. Compound angle cuts are often used in crown moldings, picture frames and similar trim materials.
1. | Loosen the Bevel Lock Lever at the rear of the saw. |
|
2. | Move the blade assembly to the desired angle. |
|
| Read the angle on the Bevel Angle Indicator. |
|
3. | Lock the blade assembly into position by | Bevel Angle |
| rotating the Bevel Lock Lever clockwise. | |
| Indicator | |
| Tighten firmly but do not | |
|
| |
4. | Make a sample cut in a piece of scrap to | Bevel Lock |
| confirm that the bevel angle is correct. | Lever |
If it is not, correct the angle before cutting.
Figure D
Operation
Maintenance
Item 61971 | For technical questions, please call | Page 11 |
