Chicago Electric 65414 manual See Table A, Nameplate, Extension Cord Length, Feet

Extension Cords

1.Grounded tools require a three wire extension cord. Double Insulated tools can use either a two or three wire extension cord.

2.As the distance from the supply outlet increases, you must use a heavier gauge extension cord. Using extension cords with inadequately sized wire causes a serious drop in voltage, resulting in loss of power and possible tool damage.

(See Table A.)

3.The smaller the gauge number of the wire, the greater the capacity of the cord. For example, a 14 gauge cord can carry a higher current than a 16 gauge cord.

(See Table A.)

4.When using more than one extension cord to make up the total length, make sure each cord contains at least the minimum wire size required.

(See Table A.)

5.If you are using one extension cord for more than one tool, add the nameplate amperes and use the sum to determine the required minimum cord size.

(See Table A.)

6.If you are using an extension cord outdoors, make sure it is marked with the suffix “W-A” (“W” in Canada) to indicate it is acceptable for outdoor use.

7.Make sure the extension cord is properly wired and in good electrical condition. Always replace a damaged extension cord or have it repaired by a qualified electrician before using it.

8.Protect the extension cords from sharp objects, excessive heat, and damp or wet areas.

RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS* (120/240 VOLT)

	NAMEPLATE				EXTENSION CORD LENGTH
	AMPERES
	(at full load)
				25 Feet	50 Feet	75 Feet	100 Feet	150 Feet
	0 – 2.0			18	18	18	18	16
	2.1	– 3.4		18	18	18	16	14
	3.5	– 5.0		18	18	16	14	12
5.1		– 7.0		18	16	14	12	12
	7.1 – 12.0			18	14	12	10	-
	12.1	– 16.0		14	12	10	-	-
16.1		– 20.0		12	10	-	-	-
	TABLE A			* Based on limiting the line voltage drop to five volts at 150% of the rated amperes.
SKU 65414			For technical questions, please call 1-800-444-3353.					Page 7