Chicago Electric 65760 manual Product Features, Operating Instructions

Models: 65760

1 14
Download 14 pages 37.5 Kb
Page 8
Image 8

PRODUCT FEATURES

 

UPPER

 

HOUSING

 

(16)

 

 

 

 

 

SPEED

 

 

 

REGULATOR

SWITCH

(17)

 

 

 

LOCK

 

 

SPEED

 

 

 

REGULATING

 

 

 

 

 

 

KNOB

 

(59)

POWER

SWITCH

(1)RIGHT AUGER (28B)

POWER CORD

&

GFCI POWER PLUG

(6)

LEFT

 

AUGER

 

(28A)

FIGURE B

 

Operating Instructions

Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this Mortar Mixer. Warning: Before each use check the operation of GFCI plug. a) Plug GFCI into power outlet. Indicator should turn on. b) Press test button. Indicator should turn off. c) Press reset button again for use. Plug indicator light must be illuminated. Do not use tool if above test fails.

1.Designate a work area that is clean and well-lit. The work area must not allow access by children or pets to prevent injury and distraction.

2.Place a mixing drum (not included) in the work area. Make sure the mixing drum is located on a flat, level ground surface.

3.Pour the material to be mixed (i.e., large batches of grout, concrete, or mortar) in the mixing drum.

4.IMPORTANT: Refer to the manufac- turer’s instructions of the material for proper mixing instructions.

5.Make sure the Power Switch (1) of the Mortar Mixer is in its “OFF” position. Then plug the tool’s GFCI Power Cord/Plug (6) into the nearest 110 volt, grounded, electrical outlet.

(See Figure B.)

6.NOTE: Route the Power Cord (6) along a safe route to reach the mix- ing drum without creating a tripping hazard or exposing the Power Cord to possible damage. The Power Cord must reach the mixing drum with enough extra length to allow free movement while working.

(See Figure B.)

7.Lower the previously attached Left Auger (28A) and Right Auger (28B) into the mixing drum.

CAUTION: Do not immerse the Mor- tar Mixer in material above the Shafts of the Augers. (See Figure B.)

8.Set the Speed Regulating Knob (59) to either “LOW” (0 to 480 RPM) or “HIGH” (0 to 650 RPM). IMPORTANT: DO NOT attempt to change speeds with the Speed Regu- lating Knob while the tool is running.

(See Figure B.)

9.Grip the Upper Housing (16) firmly with both hands and maintain a firm

SKU 65760

For technical questions, please call 1-800-444-3353.

Page 8

Page 8
Image 8
Chicago Electric 65760 manual Product Features, Operating Instructions