hot wire
foam cutter
66788
Instructions and
precautions
Distributed exclusively by Harbor Freight Tools®.
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our website at: http://www.harborfreight.com
Save these instructions. Read all precautions and instructions.
Copyright© 2009 by Harbor Freight Tools®. All rights reserved. No portion of this document or any artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools. Diagrams within this document may not be drawn proportionally. Due to continuing improvements, actual product may differ slightly from the product described herein. Tools required for assembly and service may not be included.
For technical questions or replacement parts,
please call
Specifications
Electrical Information | Adapter: 120VAC, 60Hz | |
Power: 7.5V DC, 1200mA | ||
| ||
Cutting Temperature | 428° F (220° C) | |
|
| |
Wire Size | 32 AWG (0.008” Dia.) | |
|
|
Unpacking
When unpacking, make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at
Important Assembly and
SAFETY Information
1.Always wear
2.This Hot Wire Foam Cutter gets very hot (428°), and is not a toy. Do not allow chil- dren to play with or near this item.
3.Do not leave this Hot Wire Foam Cutter lying on foam, or any combustible surface - Keep hot pad, or
4.Disconnect from power source before inspection, or cleaning - Wait at least 30 minutes to cool before performing mainte- nance.
5.Use only for intended purpose - Do not use this Hot Wire Foam Cutter to cut any material but foam.
6.This product contains or, when used, pro- duces a chemical known to the State of Cali- fornia to cause cancer and birth defects or other reproductive harm. (California Health & Safety Code § 25249.5, et seq.)
7.Maintain product labels and nameplates - These carry important safety information. If unreadable or missing, contact Harbor Freight Tools for a replacement.
Operation Instructions
1.Put on
2.Plug Adapter into 120V power outlet. This Adapter must remain plugged in while you are using the Hot Wire Foam Cutter.
3.Press the ON/OFF Button and hold. This Button will go to OFF position if released. NOTE: This is a safety precaution and must not be tampered with by using tape or other methods to hold down continuously.
4.Press hot wire into foam using gentle pres- sure to move through the workpiece. Let the Hot Wire Foam Cutter move slowly. Do not force the cutting action.
5.When you are finished cutting, release the
ON/OFF Button. Unplug the Adapter and set
REV 09c
