Page 8For technical questions, please call 1-800-444-3353.SKU 67616
speciFicatiOns
Electrical
Input 120 V~ / 60 Hz / 6.5 A (Rated)
Motor Speed 0-2500 RPM / 0-41,600 BPM
Drilling
Capacity
1/2” in Steel
5/8” in Concrete
1” in Wood
(Hammer Drill and Drill mode)
Chuck
Capacity 1/16” to 1/2”, plus Key Type Chuck
e194601
39lh
unpacKing
When unpacking, make sure that the
item is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at 1-800-444-3353 as soon as
possible.
instructiOns FOr putting intO use
read the entire impOrtant
saFetY inFOrmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.
tO prevent
seriOus injurY
FrOm accidental
OperatiOn:
turn the power switch of the tool
off and unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
note: For additional information regarding the
parts listed in the following pages, refer
to the Assembly Diagram near the end of
this manual.

assembly

Figure 1
Hex Bolt (3) Depth Gauge (1)
Gear Box (11)
Clamping Band (2)
Chuck (7)
Auxiliary
Handle (4)
1. Insert Clamping Band (2) over gear
housing behind Chuck (7) with required
handle orientation. Slightly rotating
Clamping Band will enable the two tabs
on housing to align with recesses around
clamp face. Pull clamp tightly against
housing and turn Auxiliary Handle (4) to
tighten clamp. See Figure 1.
Depending on whether left or right-2.
handed use is needed, turn the Clamping
Band around until the Auxiliary Handle
(4) is on the correct side.
Securely tighten the Hex Bolt (3) until 3.
Auxiliary Handle is fastened securely
onto Drill.
Operating instructiOns
read the entire impOrtant
saFetY inFOrmatiOn
section at the beginning of this
manual including all text under
subheadings therein before set up
or use of this product.

tool set up

tO prevent
seriOus injurY
FrOm accidental
OperatiOn: turn the tool off