y fet Sa
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION: Release the Trigger and unplug the tool from its electrical outlet before performing any procedure in this section.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
Setup
no rati Ope
ec
Maintenan
1.BEFORE EACH USE, inspect the general condition of the tool. Check for:
•loose hardware,
•misalignment or binding of moving parts,
•cracked or broken parts,
•damaged electrical wiring, and
•any other condition that may affect its safe operation.
2.After Use, wipe external surfaces of the tool with clean cloth.
3.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
4.Carbon Brush Maintenance.
The carbon brushes may require maintenance when the motor performance of the tool decreases or stops working completely. To maintain the brushes:
a.Remove the Carbon Brush Cover on each side of the motor housing.
b.Remove the carbon brushes from the housing. Keep track of which orientation the old carbon brushes were in to prevent needless wear if they will be reinstalled.
c.If either carbon brush is worn down by more than 1/2, replace them both.
d.To clean old carbon brushes before reusing them, rub the contact areas with a pencil eraser.
e.Reinsert the old carbon brushes in the same orientation to reduce wear.
f.When installing, make sure the carbon portions of the brushes contact the motor armature, and that the springs face away from the motor. Also, make sure the springs operate freely.
g.Replace the Carbon Brush Covers. Do not overtighten.
Note: New carbon brushes tend to spark when first used until they wear and conform to the motor’s armature.
Page 10 | For technical questions, please call | Item 68099 |
