Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Workpiece and Work Area Set Up
Safety
1.Designate a work area that is clean and well- lit. The work area must not allow access by children or pets to prevent distraction and injury.
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be objects, such as utility lines, nearby that will present a hazard while working.
General Operating Instructions
The Impact Wrench is equipped with a
1.Press the desired Socket (sold separately) onto the Anvil.
2.Plug the Power Cord into a 120V~ / 60Hz grounded outlet.
3.Press the LOWER part of the Trigger for clockwise (FORWARD) rotation or the UPPER part of the Trigger for counterclockwise (REVERSE) rotation.
Note: The Trigger will not activate if both settings are pressed down at the same time.
CAUTION! To prevent injury: Use both hands to operate the Impact Wrench, keeping one hand on the Handle and the other hand on the Housing. Do not hold or touch impact sockets during use.
4. When finished, release the Trigger.
Note: The amount of actual torque may vary depending on the condition of the threads and other factors. If tightening critical components, check the actual torque applied to the fastener with a mechanical torque wrench (not supplied).
5.To prevent accidents, turn off the tool and disconnect its power supply after use. Clean, then store the tool indoors out of children’s reach.
Setup
Operation
Maintenance
Item 68099 | For technical questions, please call | Page 9 |
