Zenoah BC251 If Someone Comes, Maintenance, Handling Fuel, cool down. Take a careful look

5. For safe operation

6. Never touch the muffler, spark plug, or other metallic parts of the engine while the engine is in op- eration or immediately after shut- ting down the engine. Doing so could result in serious burns or electrical shock.

•IF SOMEONE COMES

1.Guard against hazardous situa- tions at all times. Warn adults to keep pets and children away from the area. Be careful if you are ap- proached. Injury may result from flying debris.

2.If someone calls out or otherwise interrupts you while working, al- ways be sure to turn off the en- gine before turning around.

MAINTENANCE

1. In order to maintain your product in proper working order, perform the maintenance and checking operations described in the manual at regular intervals.

2.Always be sure to turn off the en- gine and disconnect the spark plug wire before performing any maintenance or checking proce- dures.

WARNING

The metallic parts reach high tem- peratures immediately after stop- ping the engine.

3.When replacing the cutting at- tachment or any other part, or

when replacing the oil or any lu- bricant, always be sure to use only ZENOAH products or products which have been cer- tified by ZENOAH for use with the ZENOAH product.

4.In the event that any part must be replaced or any maintenance or repair work not described in this manual must be performed, please contact a representative from the store nearest ZENOAH authorized servicing dealer for assistance.

5.Do not use any accessory or at- tachment other than those bear- ing the ZENOAH mark and rec- ommended for the unit.

BC251

6. Under no circumstances should
you ever take apart the product
or alter it in any way. Doing so
might result in the product be-
coming damaged during opera-	G
tion or the product becoming un-	B
able to operate properly.

HANDLING FUEL

1. The engine of the ZENOAH prod- uct is designed to run on a mixed fuel, which contains highly flam- mable gasoline. Never store cans of fuel or refill the tank of the unit in any place where there is a boiler, stove, wood fire, electrical sparks, welding sparks, or any other source of heat or fire which might ignite the fuel.

2.Never smoke while operating the unit or refilling its fuel tank.

3.When refilling the tank, always

Refill after	turn off the engine and allow it to
	cool down. Take a careful look
cooling the
engine	around to make sure that there are
	no sparks or open flames any-
	where nearby before refueling.

4.Wipe spilled fuel completely us- ing a dry rag if any fuel spillage occurs during refueling.

5.After refueling, screw the fuel cap back tightly onto the fuel tank and then carry the unit to a spot 3 m or more away from where it was refueled before turning on the en- gine.

TRANSPORTATION

1. When hand-carrying the product, cover over the cutting part if nec- essary, lift up the product and carry it paying attention to the

blade.

2. Never transport the product over rough roads over long distances by vehicle without removing all fuel from the fuel tank. If doing so, fuel might leak from the tank dur- ing transport.

GB-7