SAFETY
SETUP
Grounding
TO PREVENT ELECTRIC SHOCK AND DEATH
FROM INCORRECT GROUNDING WIRE CONNECTION:
Check with a qualified electrician if you are in doubt as to whether the outlet is properly grounded. Do not modify the power cord plug provided with the Charger. Do not use the Charger if the power
cord or plug is damaged. If damaged, have it repaired by a service facility before use. If the plug will not fit the outlet, have a proper outlet installed by a qualified electrician.
Double Insulated Tools: Tools with Two Prong Plugs
1. Tools marked “Double Insulated” do not require grounding. They have a special double insulation system which satisfies OSHA requirements and complies with the applicable standards of Underwriters Laboratories, Inc., the Canadian Standard Association, and the National Electrical Code.
| 2. Double insulated tools may be used in either of the |
| 120 volt outlets shown in the preceding illustration. |
Outlets for | (See Outlets for |
Extension Cords
Note: Extension cords must not be used with this item’s Charger.
OPERATION
MAINTENANCE
Symbology
Double Insulated
| Canadian Standards Association |
|
|
| Underwriters Laboratories, Inc. |
|
|
V~ | Volts Alternating Current |
A | Amperes |
| |
| |
n0 xxxx/min. No Load Revolutions per Minute (RPM) | |
| WARNING marking concerning Risk |
| of Eye Injury. Wear ANSI‑approved |
| safety goggles with side shields. |
Read the manual before
WARNING marking concerning Risk of Hearing Loss.
Wear hearing protection.
WARNING marking concerning Risk of Fire.
Do not cover Charger ventilation ducts. Charge on fireproof surface only. WARNING marking concerning
Risk of Electric Shock.
Properly connect Charger’s power cord to appropriate outlet. WARNING marking concerning Risk of Explosion.
Do not puncture, short, or open battery packs and do not charge damaged battery packs.
Page 6 | For technical questions, please call | Item 68853 |
