Chicago Electric 90282 manual Switch to Winch Connections Switch to Battery Fuse Connections

6.Remove the outer connection nuts from the winch motor and connect the red cable labeled (+) positive to the red terminal. Securely tighten.

7.Connect the black cable labeled (–) negative to the black terminal. Securely tighten.

Switch to Winch Connections

Switch to Battery Fuse Connections

8.Route the red and black Remote Control-to-Battery cables from the Switch on the cable of the remote control, to the battery fuse box terminal strip in the vehicle. The circuit fuse must be 70 amps.

Caution: Remote control battery cables should not be drawn taut. Leave slack for some cable movement. Do not route cables near moving engine parts, or heated areas that could melt the cable insulation.

9.Disconnect the positive (red) cable to the vehicle battery.

You will now be making an electrical connection from the Remote Control-to-Battery cables to the vehicle electrical system (the vehicle’s fuse box terminal strip).

Caution: Although the 12 VDC battery cannot shock you, it can spark and heat up cables to the melting point, and can cause serious burns if not installed and fused correctly. That is why the battery is disconnected at this time.

10.Locate an appropriate positive (+ red), fused, terminal point in the vehicle fuse box able to supply 70 amps of current and connect the red Remote Control-to-Battery cable directly to the fuse terminal (without splicing wires).

11.Connect the black negative (—) cable to the vehicle metal frame, or a ground lug on or near the battery.

12.Reconnect the red positive (+) battery cable lug to the battery.

13.Disengage the clutch by pulling out, then turning the Clutch Knob (17) to lock in the OUT position.

14.Pull the cable out about five feet for testing.

15.Test Electric Winch for proper operation. Refer to the Operation section on the next page.

SKU 90282 Page 6 REV 04/04