Chicago Electric 91332 operating instructions Operation, Battery Precautions, Charging the Battery

Operation

Battery Precautions

1.To avoid accidents, only charge the supplied batteries. Do not use a different charger adapter with this tool.

2.Do not expose the battery to rain or wet conditions.

3.To avoid damage of cable and plug, never pull the cable to disconnect the charger.

4.Do not charge the battery if either the cable or plug are damaged.

5.Repairs should be carried out by a qualified technician only.

6.Do not touch the battery poles with any conductive source.

7.Do not store the battery in a box with other metal objects.

8.Do not throw the battery in a fire.

Charging the Battery

The internal Battery does not come charged from the factory. Charge before us- ing.

1.Insert the Charger Adapter module plug into the unit connector as shown below.

Note: Never over-discharge a battery by using the tool even after tool performance is decreasing. Severe heat is most destructive to a battery; the more heat generated, the faster the battery loses power. A battery that gets too hot can be permanently damaged. Never attempt to discharge a tool’s battery by continuing to pull the tool trigger. When tool performance begins to diminish, stop the tool and

recharge the battery for optimal performance.

2.Plug the Charger Adapter module into an electrical outlet.

The red LED on the cordless Screwdriver will light. Charge the new battery from 5 to 7 hours. Battery usage time will ramp up as the new Battery is used, and recharged. Do not overcharge the battery.

Caution: Never charge Battery for more than 7 hours continuously. Charger Adapter should not be left plugged in or charging for more than 7 hours.

3.Remove the Power Adapter from the electrical outlet and store in the Blowmold case.

SKU 91332 Page