5.Squeeze the open ends of the Light Bulb Clip (10) and remove it from the Reflector. See photo below, left.
6.Carefully lift out the Light Bulb (1) assembly. See photo below, right.
Lens Reflector (5) | Light Bulb Clip (10) | Light Bulb (1) Assembly |
7.Lift up on each wire connector tab and pull out the Light Bulb (1) connectors. See photo below.
8.Discard the bad Light Bulb. Place the new Light Bulb near the work area.
Caution: Be careful not to touch the glass portion of the Light Bulb with the hands. Any finger oil or debris on the bulb will cause it to explode when it gets hot. If the new bulb is touched, clean with isopropyl alcohol and allow to dry before installing. Hold the new Light Bulb assembly by its plastic base.
Wire Connector Tab
Light Bulb (1)
Assembly
9.Push the new Light Bulb (1) connector wires onto the wire connectors coming out of the Spotlight as shown above.
10.Insert the Light Bulb (1) into the Reflector and secure with the Light Bulb Clip (10). Note that the base of the Light Bulb assembly has a slot and can only fit into the Lens Reflector (5) one way. See photos at top of page.
11.Reassemble the Lens Rim to the Spotlight Body using the existing screws. Securely tighten with the Spin Hand Wrench (not supplied). See photos at the bottom of page 6.
12.Replace the Battery (2) as described on page 5.
SKU 93175 | For technical questions, please call | Page 7 |
