11.Always recharge the Battery when the Spotlight performance begins to diminish. Severe heat is most destructive to a Battery; the more heat generated, the faster the Battery loses power. A Battery that gets too hot can be permanently damaged. Never
12.Always remove the Battery from the Spotlight before performing inspection, maintenance, cleaning procedures, or storage.
Warning:The warnings, cautions, and instructions discussed in this instruction manual cannot cover all possible conditions and situations that may occur. It must be understood by the operator that common sense and caution are fac- tors which cannot be built into this product, but must be supplied by the opera- tor.
Unpacking
When unpacking, check to make sure the following parts are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual.
Lens and Reflector (5) | Shoulder Strap (4) | |
Battery (2) Cover Latch | ||
Rubber Handle | ||
Grip |
|
Back Cover
On/Off Switch (6)
Charger Status
Indicator LEDs
Stand (3) | Stand Lock | Car Charger Plug (7) | AC Charger Plug (8) |
Charging Battery
Caution: Set the Spotlight Switch (6) to the Off position before charging. Never charge the Battery (2) for over 7 hours. Charge only until the green LED Bat- tery Status Indicator comes on. Do not operate the Spotlight while charging.
1.Unlatch the Cover Latch and open the Back Cover of the Spotlight as shown above, right.
2.Pull out and unwind the desired charging cord: the AC Charging Plug (8) for charging from a 110 VAC electrical outlet, or the DC Car Charger Plug (7) for charging from a car outlet.
SKU 93175 | For technical questions, please call | Page 4 |
