![](/images/new-backgrounds/1260961/26096127x1.webp)
To Adjust The Depth Of Cut:
1.WARNING! Prior to performing this procedure, make sure the Trigger Switch
(66)of the Saw is in its “OFF” position and the Power Cord (71) is unplugged from its electrical outlet.
2.The Saw may be adjusted to cut to a maximum depth of
3.When adjusting the depth of cut, always make sure the teeth of the Saw Blade
(10)cut (or protrude) about 1/4” through the bottom surface of the workpiece.
4.To adjust the depth of cut, pull up on the Lock Lever (50) located at the rear of the Saw. (See Figure E.)
5.Raise or lower the Base (24) until the desired cutting depth is acquired. Then, push down on the Depth Control Lever (52) to lock the Base in place.
(See Figure E.)
Depth Control Lever (52)
BASE (24)
FIGURE E
To Install A Saw Blade:
1.WARNING! Prior to performing this procedure, make sure the Trigger Switch (66) of the Saw is in its “OFF” position and the Power Cord (71) is unplugged from its electrical outlet.
2.CAUTION! Always make sure the Saw Blade (10) installed is a
SKU 94362 | For technical questions, please call | Page 14 |