OPERATING INSTRUCTIONS
To Charge A Battery Using The Battery Clamps:
8
1
3
2
NOTE: See the last page of this instruction sheet for a complete Parts List and Assembly Diagram.
1.Make sure the transmission of the vehicle is in “PARK” and the emergency brake has been set. Also, turn off the engine of the vehicle prior to connecting the Battery Charger to the battery of the vehicle.
2.Attach the RED/POSITIVE (+) Battery Clamp of the Temporary Connection Cord (8) to the POSITIVE battery terminal of the vehicle.
3.Attach the BLACK/NEGATIVE
(8) to the NEGATIVE battery terminal of the vehicle.
4.Connect the Temporary Connection Cord (8) to the Output Cord (3) of the Battery Charger.
5.Plug the Power Cord (2) of the Battery Charger into the nearest 120 volt, grounded, electrical outlet.
6.The RED (AC Power) light on the Main Unit (1) of the Battery Charger should be illuminated. This light indicates the Main Unit is receiving 120 volt electrical power from the electrical outlet.
7.The YELLOW (Charging) light on the Main Unit (1) of the Battery Charger should be illuminated. This light indicates charging is taking place.
8.The GREEN (Charged) light on the Main Unit (1) of the Battery Charger will illuminate when the vehicles’ battery is fully charged.
9.Once the vehicle’s battery is fully charged, unplug the Power Cord (2) from its 120 volt electrical outlet. Disconnect the RED/POSITIVE (+) Battery Clamp of the Temporary Connection Cord (8) from the POSITIVE battery terminal of the vehicle’s battery. Then disconnect the BLACK/NEGATIVE
10.Make sure to store all parts of the Battery Charger in a clean, dry, safe location out of reach of children.
SKU 94533 | For technical questions, please call | PAGE |
