Specifications
| 120 V~ / 60 Hz | |
Electrical | 3.55 No Load Amps / 710 Watts | |
Power Plug Type: | ||
Requirements | ||
Power Switch Type: Lockable for | ||
| ||
| continuous run | |
Motor RPM | 16,500 | |
|
| |
Drill Bit Diameter | 1/4” (Qty 2) | |
|
| |
Maximum Drilling | ||
Depth | ||
| ||
Width Between | ||
Drilling Holes | ||
| ||
Fence | ||
Adjustments | ||
|
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Initial Set Up
Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
WARNING To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Assembly
To Install The Drill Bits:
1.Rotate the two Chucks (18) so that their Hex Screws (19) are on top.
(See Figure A.)
2.Use the provided Hex Key (86) to loosen the two Hex Screws (19).
(See Figure A.)
3.Insert the shafts of the two Bits (17)
(with flat face of shank facing the screw) fully into the two Chucks (18).
4.Secure the Bits (17) into the Chucks (18) by using the Hex Key (86) to firmly tighten the Hex Screws (19).
(See Figure A.)
HEX SCREW | HEX SCREW |
(19) | (19) |
CHUCK (18) | CHUCK (18) |
FIGURE A
(TOP VIEW)
To Adjust The Cutting Depth:
1.Move the Motor Base (16) as far back as it will go. (See Figure B.)
SKU 97427 | For technical questions, please call | Page 8 |