Chicago Electric 97427 operating instructions Operating Instructions

SKU 97427

ANGLE

STOP

(3)

KNOB

(59)

2.Loosen the Screw (47), and set the cutting depth by sliding the Depth Tab (48) along the Depth Ruler (49).

(See Figure B.)

3.Retighten the Knob Screw (47) to lock the adjustment in place. (See

Figure B.)

Knob

SCREW

(47)

FIGURE B
			DEPTH
MOTOR BASE (16)	DEPTH	RULER	TAB
	(49)		(48)

To Adjust The Cutting Angle:

1.Loosen the Knob (59).

(See Figure C.)

2.Move the Angle Stop (3) to the desired angle. (See Figure C.)

3.Retighten the Knob (59).

(See Figure C.)

3.Retighten the Clamping Lever (12).

(See Figure D.)

4.NOTE: The height must correspond to half the thickness of the workpiece. Also, the groove of the Guide Plate

(8) must always be in the middle of the workpiece.

FIGURE D

HEIGHT

ADJUSTMENT

(14)

CLAMPING

LEVER

(12)

GUIDE PLATE

(8)

FIGURE C

Operating Instructions

			Read the entire Important
			Safety Information section
			at the beginning of this manual
			including all text under
			subheadings therein before set
			up or use of this product.
		The Power Switch:
To Adjust The Height:		1.	To turn on the Dowel Jointer, move
			the Power Switch (74) forward.
1. Loosen the Clamping Lever (12).			(See Figure E, next page.)
(See Figure D.)		2.	NOTE: The Power Switch (74) is
2. Move the Height Adjustment Lever			lockable for continuous running. To
(14) to the desired height, using the			lock the Power Switch in its “ON”
Scale on the Guide Plate (8).			position, move the Switch all the way
(See Figure D.)			forward until it locks in place.
			(See Figure E, next page.)
	For technical questions, please call 1-800-444-3353.			Page 9