4.Decide on which setting to choose:
Torque Settings:
Use one of the 22 settings
Use the Drill Bit setting for use with drill bits.
The different sizes of Bit Adapters
(62) are an indication of how much torque the Cordless Drill/Driver will apply to the bit before the clutch slips, allowing the bit to stop and helping to prevent damage to the screw, bit, or workpiece. The larger the screw, the more torque is applied before the clutch slips. Unless when drilling, always start with a lower number to help prevent damage. This Cordless Drill/Driver also has torque settings between the screws to allow a great- er range of control.
Drill Setting (
):
This setting essentially prevents the clutch from slipping entirely. It is de- signed for drilling, but is not advised for using a screwdriver bit because it offers no protection against stripping the head or splitting the wood.
5.To use the screwdriver function, in- sert the Bit Adapter into the Chuck as detailed in Step 1. Insert the required screwdriver bit into the Bit Adapter.
6.Set the drilling torque by turning the Torque Control (6) so that it lines up with the Arrow on the center top of the Cordless Drill/Driver.
7.When driving screws, start with a lower torque setting.
8.When drilling in light gauge metal or wood, use a wooden block to back up
the material and prevent damage to the workpiece.
9.Mark the center of the hole to be drilled with a center punch (not in- cluded) to give a Drill Bit a starting point and to prevent it from “walking”.
10.Lubricate the Drill Bit with cutting oil
(not included) when drilling iron or steel. Use a coolant (not included) when drilling nonferrous metals such as copper, brass, or aluminum.
11.Insert the fully charged Battery Pack into the Handle of the Drill/Driver.
12.The Direction Lever (38) allows you to change the rotational direction of the Drill/Driver. For a clockwise rota- tion, move the Lever forward. For a counterclockwise rotation, move the
Lever back. The center position locks the Trigger (61), to prevent the Drill/ Driver from operating.
CAUTION: Never attempt to change rotational direction while Chuck is rotating.
13.Hold the Cordless Drill/Driver firmly with both hands, as torque from the Motor can cause the tool to twist.
14.Operate Drill by squeezing Trigger.
The speed of can be controlled by varying the pressure on the Trigger.
15.If the clutch starts slipping before the screw is in all the way, stop the drill, put the Direction Lever in the center position and change the torque set- ting. Reset the rotation direction be- fore continuing.
16.If Drilling:
Use the Drill torque setting, as de- scribed above.
SKU 98544 | For technical questions, please call | Page 12 |
