SKU 98544 For technical questions, please call 1-800-444-3353. Page 9
Make sure the extension cord is prop-7. erly wired and in good electrical con-
dition. Always replace a damaged
extension cord or have it repaired by
a qualied electrician before using it.
Protect the extension cords from 8. sharp objects, excessive heat, and
damp or wet areas.
RECOmmEnDED mInImum WIRE
gaugE FOR EXTEnSIOn CORDS*
(120/240 VOLT)
namEpLaTE
ampERES
(at full load)
EXTEnSIOn CORD
LEngTH
25’
50’
75’
100’
150’
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
TaBLE a * Based on limiting the line
voltage drop to ve volts at
150% of the rated amperes.

Symbology

Double Insulated
Canadian Standards Association
Underwriters Laboratories, Inc.
V~ Volts Alternating Current
aAmperes
n0 xxxx/min. No Load Revolutions per Minute
(RPM)

SpECIFICaTIOnS

Power Source 1.3Ah Battery, 10.8v
Lithium Ion
Charge Time 3-5 Hours (after initial
charge)
Charger Input 120V ~ 60Hz
Charger Output 15V DC, 400mA
Chuck Type 3/8” Jacobs® Keyless
Max. Torque 100 in./lb.
Torque Settings 22 Clutch Settings
Variable Speed 0-600 RPM
Reversible Yes
Trigger Lock Yes
Weight 2 lb. (Drill Only)

unpaCKIng

When unpacking, make sure the item
is intact and undamaged. If any parts
are missing or broken, please call Harbor
Freight Tools at the number shown on the
cover of this manual as soon as possible.
Read the EnTIRE ImpORTanT
SaFETY InFORmaTIOn
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
TO pREVEnT
SERIOuS InjuRY
FROm aCCIDEnTaL
OpERaTIOn: Turn the power
Switch of the tool to its “OFF”
position and unplug the tool
from its electrical outlet
before assembling or making
any adjustments to the tool.
note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.