5.While standing aside of the tow path, press (and hold) the RED
Always wait until the motor has stopped before changing directions!
6.To reverse directions, press (and hold) the opposite
7.When the pulling is complete, secure the load so it cannot move in either direction.
Caution: The Winch is designed for intermittent use only, and should not be used in a constant duty application. The duration of the pulling job should be kept as short as possible. If the Winch motor becomes very hot to the touch, stop the Winch and let it cool down for several minutes. Never pull for more than one minute at or near the rated load. Do not maintain power to the Winch if the motor stalls as it can damage the motor or gears.
Maintenance
Lubrication
1.All moving parts within the Winch have been lubricated using high temperature lithium grease at the factory. No internal lubrication is required.
2.Lubricate cable periodically using a light penetrating oil.
Cable Assembly Replacement
(To be performed only by a qualified service technician.)
1.Move Cam Ring (11w) to the OUT position.
2.Extend Cable Assy. (36w) to its full length. Note how the existing cable is connected to the inside of the drum.
3.Remove old Cable Assembly and attach new one.
Caution: Do not replace with inferior cable. Always use the approved replacement part from Harbor Freight Tools.
4.Retract Cable onto cable drum being careful not to allow kinking.
General
1.Keep vehicle battery in good condition.
2.Be sure that the Winch battery cables are not drawn tight against any surfaces which could possibly damage them.
3.Periodically remove and clean cable connections to the battery fuse box and chassis ground. Corrosion will reduce performance or may cause a short.
4.Cover the cables and Winch when not in use.
SKU 91780 | For technical questions, please call | Page 8 |
