Unfolding the stroller
•Keep children away from stroller while unfolding.
•Position the stroller with the handle bar closest to you.
•Release the locking latch located on the right side by lifting the lever off of the extended rivet. See Figure 2.
•Lift up slightly on the handle of the stroller. Then place one foot onto the rear platform and pull up and back on the handle until both side frame bars snap into their locking positions in the frame.
CAUTION: While unfolding the stroller, be careful to keep your fingers from being pinched by moving parts.
•Lock the safety latches on the lower portion of each side of the stroller by pushing the lever down over the extended rivet. See Figure 3.
•Ensure that the stroller is completely opened and the safety latches are secured before ANY use of the stroller.
Figure 2 | Figure 3 |
WARNING
ALWAYS secure the safety latches on the sides of the stroller
when it is in the unfolded use position. This will prevent collapse of the stroller should the handle trigger locks be accidentally opened.
Installing the Front Wheels
•Take one of the double wheel sets and locate the small hole in the rotating bracket that is inside the red lever.
•Push the front axle into this hole and keep pushing the wheel set onto this axle until you hear an audible click. See Figure 4.
•Pull downward on the wheel set to be sure that it has locked into position on the axle.
•Repeat this same procedure for the other wheel set.
•When assembled properly, both wheel sets should rotate and roll smoothly when the stroller is pushed.
Page | The Big Caboose |
