CM6QH SERIES | Installation Instructions |
INSTALLATION
Installation
1.Secure track to top of cabinet.
2.Align centerline on track with center of cabinet opening, and keep the front of the track mounting flange flush with front of the cabinet. (See Firgure 2)
3.Secure Support Arms to the top of the cabinet.
Door Hanging Procedure
IMPORTANT ! : Doors should be made of a
1.Predrill the tops of the doors as shown with 1/2" clearance holes for the door hanger pendant bolts.
2.Mount he door hangers to the top of the 4 doors. After mounting, check to make sure that the pendant bolts can be freely adjusted in and out of the door hangers. (See figure 3)
3.Mount the guidewheel plates to the bottom of the doors. (See figure 4)
4.Hang the 2 Rear doors onto the mechanism carriages located on the underside of the track. Use the carriages closest to the ends of the track. First engage the guidewheel
plate wheel into the track area built into the base. Then tip the top of the door into the mechanism and engage the pendant bolts into the slots in the carriages. After hanging the doors spin the locking nut on the pendant bolts up so that the nut is finger tight against the bottom of the carriage. (See figure 3)
5.Repeat his procedure for the 2 Front doors using the center carriages.
6.Adjust the doors for plumb by using a 7/16" wrench and turning the adjustment nut on the pendant bolt. Tightening the bolt into the door hanger will raise that corner of the door, loosening the bolt will lower the corner. After all doors have been adjusted, use one wrench to hold the adjustment nut and another to tighten the locking nut on the pendant bolts against the carriage.
IMPORTANT ! : Doors should be adjusted so that they are even across the top. Do not adjust the doors too high as this will cause the guidewheel plates to rub and possibly restrict the movement of the doors. Check to make sure that the front door guidewheel plates clear the bottom of the rear doors as they move.
Figure 1
4
