Installation Instructions | FHP |
|
|
DISPLAY INSTALLATION
Install the display as follows:
VESA Compliant Flush Mounting
CAUTION: If monitor uses a screw size other than M4, DO NOT use the M4 screws provided. Using the wrong screws could result in damage to your display.
1.Start two M4 X .7 X 12mm Phillips pan head screws in the top mounting holes of your display.
2.Matching the hole pattern on your display with the hole pattern on the mount, hang the mount from the two screws started in Step A (see Figure 3).
3.Install two remaining Phillips pan head screws through the mount and into the mounting holes of your display.
4.Secure your display to the mount by tightening the four Phil- lips pan head screws.
5.Connect and secure power/audio/video cables, making sure to leave sufficient slack to allow for movement of the display.
VESA Compliant Recessed Mounting
1. Place four 1/2” X 3/8” Nylon spacers or four 1/2” X 3/4” | Figure 3. Install Flush Mount Display on Bracket |
| |
Nylon spacers, as necessary, over the mounting holes of your |
|
display (see Figure 4). |
|
2.Place the mount over the Nylon spacers, matching the hole pat- tern on your display (75mm or 100mm) with the hole pattern on the mount.
3.Using four M4 X .7 X 20mm Phillips pan head screws for 1/2” X 3/8” Nylon spacer installation or four M4 X .7 X 30mm Phillips pan head screws for the 1/2” X 3/4” Nylon spacer installation, secure the mount to your display.
4.Connect and secure power/audio/video cables, making sure to leave sufficient slack to allow for movement of the display.
1.Contact Chief Manufacturing for custom interface brackets.
Figure 4. Install Recessed Mount Display on Bracket
5
