Installation Instructions | FWDIW Series |
Display Installation
The mounting holes on the back of the display will either be flush with the back surface, or recessed into the back surface. Refer to the applicable installation procedure below.
Flush Mount Display
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Using screws of improper size may damage your display! Proper screws will easily and completely thread into display mounting holes. Ensure that screws are not too long.
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Inadequate thread engagement in display may cause display to fall! Back out screws ONLY as necessary to allow installation of Centris bracket!
1.Partially install two screws (R1) into upper mounting holes in display back. (See Figure 4)
NOTE: Leave at least 1/8" of each screw protruding out back of display.
1 |
(R1) x2 |
Figure 4
2.Align two screws (R1) in display back with upper teardrop mounting holes in faceplate. (See Figure 5)
3.Place two screws (R1) in display back into upper teardrop mounting holes in faceplate and lower display until screws are seated in lower area of teardrop mounting holes.
(See Figure 5)
4.Install two screws (R1) through lower mounting holes in faceplate and into display back. (See Figure 5)
5.Tighten all hardware.
2 |
3 |
4 |
(R1) x 2 |
Figure 5
Recessed Mount
1.Place four spacers (R3, R4) over each mounting hole in display back.
2.Align teardrop mounting holes in faceplate with holes in spacers (R3, R4).
3.Install four Phillips pan head screws (R2) through faceplate and spacers (R3, R4) and into mounting holes in back of display.
4.Tighten all screws.
2 |
1 |
3 |
(R2) x 4 |
(R3, R4) x 4 |
Figure 6
5
