KSA1021 | Installation Instructions |
INSTALLATION
WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! DO NOT substitute hardware. Only use hardware provided or specified by manufacturer.
1.Remove hardware securing Centris head assembly to height adjustable arm.
2.Set hardware aside for
IMPORTANT ! : DO NOT DISCARD HARDWARE! Hardware will be used when installing laptop tray accessory.
3.Orient vertical tray mounting bracket as show in figure below. (See Figure 1)
4.Slide spacer (C) into bottom of height adjustable arm.
5.Place UHM washer (B) on upper area of height adjustable arm.
6.Slide height adjustable arm with spacer and UHM washer
(B)in between mounting tabs in vertical tray mounting bracket (H) until mounting holes in arm and bracket align. (See Figure 1)
7.Place UHM washer, removed during step 1, over mounting hole in upper mounting tab of vertical tray mounting bracket.
(H).
8.Slide spacer, removed during step 1, down through UHM washer and mounting hole in vertical tray mounting bracket
(H)and into height adjustable arm. (See Figure 1)
9.Place two flat washers and one Nylon washer, removed during step 1, onto socket head screw (J) provided with tray accessory. (See Figure 1)
10.Align mounting hole in Centris head assembly with mounting hole in vertical tray mounting bracket (H).
11.Slide socket head screw (J) with washers down through Centris head assembly and height adjustable arm.
12.Hold hex nut, removed during step 1, in bottom of height adjustable arm and secure Centris head assembly and vertical tray mounting bracket (H) to height adjustable arm by tightening socket head screw (J) using 1/4" hex wrench.
|
| (D) x 1 |
|
|
| 9 |
|
|
| 8 |
|
1 |
| 7 | (B) x 1 |
|
| ||
| (H) x 1 |
| 5 |
|
|
| |
| 3 | 6 |
|
|
|
| |
|
|
| 4 |
|
| 12 | (C) x 1 |
Figure 1
4
