Model: | Installation Instructions |
NOTE: Equally tighten screws (230) against front pole mount (210) and rear (220) pole clamps.
(see Figure 4)
| (230) |
Keep equal | (220) |
distance between |
|
mount and |
|
clamp when |
|
tightening |
|
| (210) |
Figure 4:
4.Secure rear pole clamp (220) to front pole mount
(210)and pole by tightening three BHCS (230) using 5/32" hex key (120). (see Figure 3)
KTP-220, 320, and 440 Assembly
To assemble the
1.Assemble pole (50) to base (40) using one
2.Assemble pole clamp back (240) to pole mount front using two FW (250) and two BHCS (260) using a 5/32" hex key. (see Figure 5)
3.Secure pole mount back (240) to pole mount front and pole by tightening two BHCS (260) using a 5/32" hex key.
Pole |
Pole Mount front |
with Array |
(250) |
(260) |
Pole Clamp Back (240) |
Figure 5: Assemble Array Rail to Pole
Display Installation
Attach Centris Head to Flush Mount Display
CAUTION!
CAUTION: If display uses a screw size other than those included in the kit, DO NOT use the screws provided. Using the wrong screws could result in damage to your monitor.
1.Install two M4 x 12mm Phillips pan head screws (160) into two upper mounting holes in display back.
(see Figure 6)
NOTE: DO NOT fully tighten at this time.
2.Hang display on Centris head. (see Figure 7)
3.Install bottom two M4 x 12mm Phillips pan head screws (160) through Centris head mounting holes and into lower mounting holes in display back.
4.Tighten ALL four M4 x 12mm Phillips pan head screws (160). (see Figure 8)
M4 x 12mm Phillips Pan Head Screw (30)
Display
Figure 6: Prepare Display
Display
(20, 30)
Centris Head
Figure 7: Hang Display
4