Installation Instructions | Model: |
Display
Centris Head
(20, 30)
(160)
Figure 8: Secure Display to Centris Bracket
Attach Centris Head to Recessed Mount Display
NOTE: Refer to Table 3 to select the applicable screw and spacer combination.
1.Uninstall end lock using the 5/32" hex key (120). (see Figure 9)
2.Remove Centris head from array rail (20, 30).
Centris Head
Square Nut
End Lock | (20, 30) |
|
|
| Figure 9: Remove End Lock(s) |
(20, 30)
Centris Head
Figure 10: Slide Centris Bracket off Array Rail
3.Place display face down on a clean dry surface.
4.Place four 3/8" or 3/4" nylon spacers (190 or 200) over four mounting holes in display back (see Figure 11).
5.Align Centris head mounting holes with four nylon spacers (see Figure 11).
6.Secure Centris head to display using four
M4 x 20mm Phillips pan head screws (170), or four M4 x 30mm Phillips pan head screws (180)
(see Figure 11).
Phillips Pan Head Screw (170 or 180)
Centris Head
Spacer
(190 or 200)
Display
Figure 11: Mount Centris Bracket to Display
7.Slide display with Centris bracket onto array rail (20, 30) (see Figure 12).
NOTE: Repeat previous steps for each additional display.
8.Reinstall end locks into mounting rail using the 5/32" hex key (120) (see Figure 13).
Display with Centris Bracket
(20, 30)
Figure 12: Mount Display with Centris Bracket to
Array Rail
5