Chief Manufacturing LCD2TS installation instructions For clarity only

LCD2TS Installation Instructions

6.Insert four 1/4"-20x1-1/4" (J) button head cap screws from the top of the projector arm. (See Figure 4)

(A)	8	(J)x4
(L)x4
	RPM not shown
	for clarity only

Figure 4

7.Place a 1/4" flat washer (L) onto each screw.

8.Hold the RPM (with interface brackets attached) to the bottom of the projector arm and tighten the screws through the washers and into the interface brackets.

9.Proceed with Steps 5 - 10 from For RPA Models Only section

6