Installation Instructions | MCS6000 Series |
INSTALLATION
WARNING: FAILURE TO PROVIDE ADEQUATE STRUCTURAL STRENGTH FOR THIS COMPONENT CAN RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! It is the installer’s responsibility to make sure the structure to which this component is attached can support five times the combined weight of all equipment. Reinforce the structure as required before installing the component.
Attaching MCS to NPT Pipe
CAUTION: Watch for pinch points. Do not place fingers between moveable parts.
1.Thread the MCS (A) onto the existing
2.Using the hex head wrench (B) tighten the set screw into the MCS threaded collar to prevent movement of the mount. (See Figure 1)
NPT |
| |
Pipe |
| |
2 | Set | |
Screw | ||
| ||
(A) |
|
Figure 1
Attaching Interface Bracket to Display
1.Attach interface bracket to display following instructions included with interface bracket kit.
Attaching Displays to MCS
1.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in MCS. (See Figures 2, 3 and 4)
1 |
(A) |
Display |
Figure 2
WARNING: DISPLAY MAY WEIGH IN EXCESS OF 40 LBS! Always use two people and proper lifting techniques when installing or positioning display on MCS.
2.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes. (See Fig. 2, 3 and 4)
(A) |
| |
Interface Bracket |
| |
(will vary in | Back | |
appearance) | ||
of Display | ||
|
Figure 3
WARNING: IMPROPER INSTALLATION CAN LEAD TO DISPLAY FALLING CAUSING SERIOUS PERSONAL INJURY OR DAMAGE TO EQUIPMENT! Ensure mounting buttons are completely engaged in mounting holes.
NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 4).
5
