Installation Instructions | MSM/MTM Series |
3d |
3e |
Knobs to outside |
of brackets |
Figure 7
3.If necessary, the tilt interface bracket knobs may be switched to allow the interface brackets to be reversed. (See Figure 7)
a.Remove display from mount.
b.Remove interface brackets from display.
c.Hold the right interface bracket horizontally, tightly gripping it so that spacers do not move.
d.Remove the knob, washer and screw.
e.Replace the knob, washer and screw in the opposite order, with the knob on the inside of the bracket.
f.Switch the right interface bracket to the left side of the wall mount.
g.Repeat Steps 3c through 3f with the left interface bracket.
Attaching Screen to Wall Mount
1.Adjust Velcro® pull strap (if necessary) so it does not extend beyond bottom of screen. (See Figure 8)
NOTE: Do NOT allow both interface brackets to be located on same side of wall bracket. (See Figure 8)
NOTE: NEVER place both interface brackets to one side of the wall mount center line! (See Figure 8)
Center Line (CL)
Pullstraps |
NEVER place both interface brackets to one side of the wall mount center line (CL)!
Both interface brackets must NEVER be located to one side of the wall bracket!
Figure 8
9
