Chief Manufacturing PCM Series Mount Assembly and Installation, Display Installation, Pcm Series

PCM SERIES Installation Instructions

Mount Assembly and Installation

1.Fold tube out until tube mounting bracket rests against faceplate mounting bracket. (See Figure 2)

2.Secure tube to faceplate mounting bracket using 3/16" hex wrench (C) and two 5/16-18 x 1/2" button head cap screws

(D).

3.Tighten all hardware.

	1
2	(D) x 2

Figure 2

4.Thread the tube assembly (A) onto 1-1/2” NPT.

NOTE: The product is suitable for use with a Listed ceiling plate which can accommodate 1-1/2" NPT pipe, and has a rated weight capacity of 200 lbs (91 kg).

5.Secure faceplate (B) to faceplate mounting bracket using 3/16" hex wrench (C) and four 5/16-18 x 1/2" button head cap screws (D).

(A)x1

(B) x 1

5 (D) x4

Figure 3

Display Installation

If the mounting pattern of the display being installed is a VESA standard 200 x 200 pattern the mounting buttons can be installed directly to the back of the display. If the display has any other mounting pattern an interface bracket must be obtained before proceeding. Consult a Chief Customer Service representative if an interface bracket is required by calling 1-800-582-6480 or visit www.chiefmfg.com.

WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Displays can weigh in excess of 40 lbs (18.1kg). ALWAYS use two people and proper lifting techniques when installing display.

WARNING: IMPROPER INSTALLATION CAN LEAD TO MOUNT FALLING CAUSING SEVERE PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make sure mounting buttons on display are properly seated in mounting holes in faceplate.

To install display:

1.While supporting both sides of display, align four mounting buttons on display or interface bracket with four mounting holes in faceplate. (See Figure 4)

2.Lower display into place listening for audible "click" to ensure recessed area of mounting buttons are properly seated in lower area of mounting holes and "click lock" mechanism has engaged. (See Figure 4) and

(See Figure 5)

1

2

Figure 4

NOTE: Holes are provided in the faceplate for use with a padlock or similar locking device, if desired. In addition, the pin and nut may be removed from the upper holes and moved to the lower holes for use as a more permanent locking device. (See Figure 5)

4