
PCS SERIES | Installation Instructions |
To use as a more
permanent lock, remove 4 pin and nuts and move
to lower holes.
5
A padlock or bolt may
be placed through latch holes
Figure 4
Removing Display
1.Disconnect all power/audio/video cables.
2.Remove bolt or padlock from faceplate (if used). (See Figure 5)
NOTE: The pin may have been used as a more permanent locking device. If so, remove nut and pin and move from the lower holes to the upper holes.
3.Pull back on flag on upper mounting hole and press pin down into "Open" position. (See Figure 5)
WARNING: THE DISPLAY MAY WEIGH IN EXCESS OF 40 LBS EACH! Always use two people and proper lifting techniques when installing or positioning display.
4.Carefully lift display from mount.
5.Lift up on pin and place flag back against faceplate to return it to "Closed" position. (See Figure 5)
1 | Remove bolt |
|
| or padlock | 2 |
| if used | |
Pin in |
| |
"Closed" |
| |
position - |
| |
move to |
| |
"Open" |
| |
position to |
| |
remove |
| |
display |
| |
| 4 |
|
Pin in |
| |
"Open" |
| |
position - |
| |
move to |
| |
"Closed" |
| |
position |
| |
after display |
| |
is removed. |
|
Figure 5
Adjusting Display
CAUTION: Watch for pinch points. Do not place fingers between moveable parts.
Adjusting Roll
1.Using a 9/16" wrench, loosen the Nylock roll adjustment nut on back of mounting plate. (See Figure 6)
2.Tilt the faceplate left or right as required.
3.TIghten nut.
NOTE: Do NOT overtighten fasteners.
Adjusting Pitch
1.Adjust display to the desired pitch.
2.Using the 5/32" hex head wrench (B), tighten the pitch adjustment screw to hold mount in position. (See Figure 6)
6