Installation
•Do not install this appliance if it is damaged in any way. Installing a not install this appliance if it is damaged in any way. Installing a
damaged appliance may invalidate the warranty. damaged appliance may invalidate the warranty.
• The water supply tap should be located in an adjacent cupboard so that it
• The water supply tap should be located in an adjacent cupboard so that it can be accessed after installation.
can be accessed after installation.
• Ensure the appliance is level by adjusting the feet as necessary. The
dishwasher is equipped with an adjustable rear foot that can be raised or
• Ensure the appliance is level by adjusting the feet as necessary.
lowered by means of an adjustment screw, located in the centre of the kick plate.
• Only use the water inlet supplied with the appliance.
• Only use the water inlet supplied with the appliance.
• If the waterr pressureisisabove1010bar,bar,aapressurereliefreliefvalvevalveshouldshouldbebeusedused. .
• After connectingthe watersupply,check to ensure there are no leaks.
thecheck to ensure there are no leaks.
•The water outlet can either be connected to a water drain or to a sink outlet
•The water outlet can either be connected to a water drain or to a sink outlet spigot. This connection should be at a minimum of 50 cm and a maximum of spigot. This connection should be at a minimum of 50 cm and a maximum
110 cm from the floor. The drain hose should be no longer than 4m in length toof 110ensurecm goodfrom theperformanceloor. Thefromdraintheosedishouldwasherbe. no longer than 4m in
•lengthTo preventto ensuresiphoning,good performanceensure that thefromwaterhe outletdishwashernot. pushed too far into the waste standpipe. The lowest part of the water outlet should be level with the bottom basket of the dishwasher.
•When connecting to the sink, ensure that the waste pipe runs higher than the level of the sink bowl to prevent siphoning.
fig. 13
10cm recommended |
100cm |
4cm |
40cm |
fig. 14 |
fig. 15
16
