Failure Codes and Troubleshooting
Problem | Possible cause | |
|
| |
| Check the plug, fuse and circuit breakers of the mains supply. | |
The programme will not start | The water tap is turned off. | |
The dishwasher door is not fully closed. | ||
| ||
| The water inlet filter or the machine filters are blocked. | |
|
| |
Water remains inside the dishwasher at the end of a programme | The water drain hose is blocked or kinked. | |
The filters are blocked. | ||
| ||
|
| |
| Power failure. | |
The dishwasher stops in the middle of a programme | Water inlet failure. | |
| Programme is on standby. | |
|
| |
| Poor loading of dishes hinders wash performance. | |
| Insufficient detergent added. | |
Wash performance is of a low standard | Inappropriate wash programme selected. | |
Spray arm is blocked. | ||
| ||
| Filters clogged or incorrectly fitted. | |
| Water drain pump is blocked. | |
|
| |
| Insufficient detergent added. | |
| Rinse aid setting is too low. | |
White stains on the dishes | Insufficient dishwasher salt added. | |
| Water softener setting is too low. | |
| Salt compartment cap may not be completely closed. | |
| A programme without a drying stage was selected. | |
The dishes are not completely dry at the end of a programme | Rinse aid setting is too low. | |
| Dishes unloaded too soon (allow time for drying). | |
|
| |
| Different sets of cutlery should be kept separate. | |
There are rust stains on the dishes | Too much salt (water softener setting is too high). | |
Salt compartment cap not completely closed. | ||
| ||
| Poor appliance earth (check mains electrical supply). | |
|
| |
The door is not opening or closing properly | Door tension not correctly adjusted for the decor door. | |
|
|
14
